Redox-Active Polymers Designed for the Circular Economy of Energy Storage Devices
AuthorsTan, Siew Ting Melissa
Quill, Tyler J.
Takacs, Christopher J.
Embargo End Date2022-09-08
Permanent link to this recordhttp://hdl.handle.net/10754/671136
MetadataShow full item record
AbstractElectrochemical energy storage is a keystone to support the rapid transition to a low-carbon-emission future for grid storage and transportation. While research on electrochemical energy storage devices has mostly dealt with performance improvements (energy density and power density), little attention has been paid to designing devices that can be recycled with low cost and low environmental impact. Thus, next-generation energy storage devices should also address the integration of recyclability into the device design. Here, we demonstrate recyclable energy storage devices based on solution-processable redox-active conjugated polymers. The high electronic and ionic charge transport in these polymers enables the operation of single-phase electrodes in aqueous electrolytes with C-rates >100 with good electrochemical stability when the cell is charged to 1.2 V. Finally, we demonstrate the recyclability of these devices, achieving >85% capacity retention in each recycling step. Our work provides a framework for developing recyclable devices for sustainable energy storage technologies.
CitationTan, S. T. M., Quill, T. J., Moser, M., LeCroy, G., Chen, X., Wu, Y., … Giovannitti, A. (2021). Redox-Active Polymers Designed for the Circular Economy of Energy Storage Devices. ACS Energy Letters, 3450–3457. doi:10.1021/acsenergylett.1c01625
SponsorsA.G. and A.S. acknowledge funding from the TomKat Center for Sustainable Energy at Stanford University and the StorageX initiative. A.S. and S.T.M.T. gratefully acknowledge support from the National Science Foundation Award CBET #1804915. T.J.Q. and G.L. acknowledge support from the NSF Graduate Research Fellowship Program under grant DGE-1656518. Part of this work was performed at the Stanford Nanofabrication Facilities (SNF) and Stanford Nano Shared Facilities (SNSF), supported by the National Science Foundation as part of the National Nanotechnology Coordinated Infrastructure under award ECCS-1542152. The authors acknowledge financial support from KAUST, including the Office of Sponsored Research (OSR) award nos. OSR-2018-CRG/CCF-3079, OSR-2019-CRG8-4086, and OSR-2018-CRG7-3749. The authors acknowledge funding from an ERC Synergy Grant SC2 (610115). Use of the Stanford Synchrotron Radiation Lightsource, SLAC National Accelerator Laboratory, is supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-76SF00515.
PublisherAmerican Chemical Society (ACS)
JournalACS Energy Letters