Understanding multi-stage HCCI combustion caused by thermal stratification and chemical three-stage auto-ignition
dc.contributor.author | Ben Houidi, Moez | |
dc.contributor.author | AlRamadan, Abdullah | |
dc.contributor.author | Sotton, Julien | |
dc.contributor.author | Bellenoue, Marc | |
dc.contributor.author | Sarathy, Mani | |
dc.contributor.author | Johansson, Bengt | |
dc.date.accessioned | 2020-07-26T06:50:47Z | |
dc.date.available | 2020-07-26T06:50:47Z | |
dc.date.issued | 2020-07-23 | |
dc.date.submitted | 2019-11-07 | |
dc.identifier.citation | Ben Houidi, M., AlRamadan, A., Sotton, J., Bellenoue, M., Sarathy, S. M., & Johansson, B. (2020). Understanding multi-stage HCCI combustion caused by thermal stratification and chemical three-stage auto-ignition. Proceedings of the Combustion Institute. doi:10.1016/j.proci.2020.05.047 | |
dc.identifier.issn | 1540-7489 | |
dc.identifier.doi | 10.1016/j.proci.2020.05.047 | |
dc.identifier.uri | http://hdl.handle.net/10754/664391 | |
dc.description.abstract | The Homogeneous Charge Compression Ignition (HCCI) concept shows great potential for improving engine efficiency and reducing pollutant emissions. However, the operation with this concept in Internal Combustion (IC) engines is still limited to low speed and load conditions, as excessive Pressure Rise Rates (PRR) are generated with its fast auto-ignition. To overcome this limitation, the use of moderate thermal and charge stratification has been promoted. This leads to multi-stage ignition, and thus a potentially acceptable PRR. Recently Sarathy et al. (2019), three-stage auto-ignition has been emphasized as a chemical phenomenon where the thermal runaway is inhibited during the main ignition event. The current paper demonstrates experimental evidence on this phenomenon observed during n-heptane and n-hexane auto-ignition at lean diluted conditions in a flat piston Rapid Compression Machine (RCM). Multi-stage ignition events caused by either chemical kinetics or by the well-known thermal stratification of this type of RCM are clearly identified and differentiated. The combination of these two factors seems to be a suitable solution to overcome PRR limitations. | |
dc.description.sponsorship | The experimental work was supported by the French research agency (Association Nationale de la Recherche et de la Technologie ANRT), Renault S.A., and PPRIME Institute during the Ph.D. thesis of M. Ben Houidi (CIFRE N:384/2010). The simulation work was supported by King Abdullah University of Science and Technology (KAUST) Office of Sponsored Research (OSR) with funds given to the Clean Combustion Research Center. We acknowledge funding from the KAUST Clean Fuels Consortium and its member companies. | |
dc.publisher | Elsevier BV | |
dc.relation.url | https://linkinghub.elsevier.com/retrieve/pii/S154074892030095X | |
dc.rights | NOTICE: this is the author’s version of a work that was accepted for publication in Proceedings of the Combustion Institute. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Proceedings of the Combustion Institute, [, , (2020-07-23)] DOI: 10.1016/j.proci.2020.05.047 . © 2020. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/ | |
dc.title | Understanding multi-stage HCCI combustion caused by thermal stratification and chemical three-stage auto-ignition | |
dc.type | Article | |
dc.contributor.department | Chemical Engineering Program | |
dc.contributor.department | Clean Combustion Research Center | |
dc.contributor.department | Combustion and Pyrolysis Chemistry (CPC) Group | |
dc.contributor.department | Mechanical Engineering | |
dc.contributor.department | Mechanical Engineering Program | |
dc.contributor.department | Physical Science and Engineering (PSE) Division | |
dc.identifier.journal | Proceedings of the Combustion Institute | |
dc.rights.embargodate | 2022-07-23 | |
dc.eprint.version | Post-print | |
dc.contributor.institution | ISAE-ENSMA, Institut PPRIME, departement Fluide Thermique Combustion, BP 40109, Teleport2, 1 avenue Clement Ader, F86961 Futuroscope Chasseneuil-du-Poitou Cedex, France. | |
kaust.person | Ben Houidi, Moez | |
kaust.person | AlRamadan, Abdullah | |
kaust.person | Sarathy, Mani | |
kaust.person | Johansson, Bengt | |
dc.date.accepted | 2020-05-27 | |
refterms.dateFOA | 2020-07-26T13:56:16Z | |
kaust.acknowledged.supportUnit | Clean Combustion Research Center | |
kaust.acknowledged.supportUnit | Office of Sponsored Research (OSR) | |
dc.date.published-online | 2020-07-23 | |
dc.date.published-print | 2020-07 |
Files in this item
This item appears in the following Collection(s)
-
Articles
-
Physical Science and Engineering (PSE) Division
For more information visit: http://pse.kaust.edu.sa/ -
Chemical Engineering Program
For more information visit: https://pse.kaust.edu.sa/study/academic-programs/chemical-engineering/Pages/home.aspx -
Mechanical Engineering Program
For more information visit: https://pse.kaust.edu.sa/study/academic-programs/mechanical-engineering/Pages/home.aspx -
Clean Combustion Research Center