2D matrix engineering for homogeneous quantum dot coupling in photovoltaic solids
Kirmani, Ahmad R.
Proppe, Andrew H.
García de Arquer, F. Pelayo
Quan, Li Na
Kelley, Shana O.
Sargent, Edward H.
KAUST DepartmentKAUST Solar Center (KSC)
Material Science and Engineering Program
Organic Electronics and Photovoltaics Group
Physical Science and Engineering (PSE) Division
KAUST Grant NumberOSR-2017-CPF-3321-03
Online Publication Date2018-04-23
Print Publication Date2018-06
Permanent link to this recordhttp://hdl.handle.net/10754/627674
MetadataShow full item record
AbstractColloidal quantum dots (CQDs) are promising photovoltaic (PV) materials because of their widely tunable absorption spectrum controlled by nanocrystal size1,2. Their bandgap tunability allows not only the optimization of single-junction cells, but also the fabrication of multijunction cells that complement perovskites and silicon 3 . Advances in surface passivation2,4-7, combined with advances in device structures 8 , have contributed to certified power conversion efficiencies (PCEs) that rose to 11% in 2016 9 . Further gains in performance are available if the thickness of the devices can be increased to maximize the light harvesting at a high fill factor (FF). However, at present the active layer thickness is limited to ~300 nm by the concomitant photocarrier diffusion length. To date, CQD devices thicker than this typically exhibit decreases in short-circuit current (JSC) and open-circuit voltage (VOC), as seen in previous reports3,9-11. Here, we report a matrix engineering strategy for CQD solids that significantly enhances the photocarrier diffusion length. We find that a hybrid inorganic-amine coordinating complex enables us to generate a high-quality two-dimensionally (2D) confined inorganic matrix that programmes internanoparticle spacing at the atomic scale. This strategy enables the reduction of structural and energetic disorder in the solid and concurrent improvements in the CQD packing density and uniformity. Consequently, planar devices with a nearly doubled active layer thicknesses (~600 nm) and record values of JSC (32 mA cm-2) are fabricated. The VOC improved as the current was increased. We demonstrate CQD solar cells with a certified record efficiency of 12%.
CitationXu J, Voznyy O, Liu M, Kirmani AR, Walters G, et al. (2018) 2D matrix engineering for homogeneous quantum dot coupling in photovoltaic solids. Nature Nanotechnology. Available: http://dx.doi.org/10.1038/s41565-018-0117-z.
SponsorsThis publication is based in part on work supported by the Natural Sciences and Engineering Research Council of Canada, by the Ontario Research Fund Research Excellence Program and by Award OSR-2017-CPF-3321-03 made by King Abdullah University of Science and Technology (KAUST). Some of the GIWAXS/GISAXS measurements were performed at the Cornell High Energy Synchrotron Source (CHESS), supported by the NSF Award DMR-1332208. This work also made use of the South Carolina SAXS Collaborative using a SAXSLab Ganesha for the GISAXS/GIWAXS measurements, supported by the NSF Major Research Instrumentation program (award no. DMR-1428620). We thank U. Jeng for the GIWAXS tested at the National Synchrotron Radiation Research Center, Taiwan, China. We thank L. Goncharova for assistance with RBS measurements. We thank D. Kopilovic, E. Palmiano, L. Levina and R. Wolowiec for the technical support.
- Measuring charge carrier diffusion in coupled colloidal quantum dot solids.
- Authors: Zhitomirsky D, Voznyy O, Hoogland S, Sargent EH
- Issue date: 2013 Jun 25
- Stabilizing Surface Passivation Enables Stable Operation of Colloidal Quantum Dot Photovoltaic Devices at Maximum Power Point in an Air Ambient.
- Authors: Choi J, Choi MJ, Kim J, Dinic F, Todorovic P, Sun B, Wei M, Baek SW, Hoogland S, García de Arquer FP, Voznyy O, Sargent EH
- Issue date: 2020 Feb
- High-Efficiency Photovoltaic Devices using Trap-Controlled Quantum-Dot Ink prepared via Phase-Transfer Exchange.
- Authors: Aqoma H, Al Mubarok M, Hadmojo WT, Lee EH, Kim TW, Ahn TK, Oh SH, Jang SY
- Issue date: 2017 May
- Depleted-heterojunction colloidal quantum dot solar cells.
- Authors: Pattantyus-Abraham AG, Kramer IJ, Barkhouse AR, Wang X, Konstantatos G, Debnath R, Levina L, Raabe I, Nazeeruddin MK, Grätzel M, Sargent EH
- Issue date: 2010 Jun 22
- Colloidal Quantum Dot Bulk Heterojunction Solids with Near-Unity Charge Extraction Efficiency.
- Authors: Choi MJ, Baek SW, Lee S, Biondi M, Zheng C, Todorovic P, Li P, Hoogland S, Lu ZH, de Arquer FPG, Sargent EH
- Issue date: 2020 Aug