KAUST DepartmentComputer, Electrical and Mathematical Sciences and Engineering (CEMSE) Division
Electrical Engineering Program
Permanent link to this recordhttp://hdl.handle.net/10754/626052
MetadataShow full item record
AbstractA novel half mode waveguide based ferrite isolator design is presented in this work. For the first time, tunability of the isolation band is demonstrated for a ferrite isolator. Instead of using the conventional antisymmetric bias the isolator requires a single direction of the magnetic bias field due to the half mode operation. Yttrium Iron Garnet (YIG) is used as the substrate for the device. The metallic walls of the waveguide are realized using inkjet printing. The magnetic biasing applied to the waveguide causes the RF waves to experience negative permeability in one direction of propagation hence providing isolation for this direction. For an applied bias of 3000 Oe, the device provides a maximum isolation figure of merit of 76.7 dB at 7.5 GHz. The isolation band can be controlled by changing the applied magnetostatic bias. As the bias is varied from 1500 Oe to 3500 Oe the center frequency of the isolation band varies from 4.45 GHz to 9 GHz. The measured response of the isolator shows that it can be integrated in any RF system requiring lower cost and good isolation.
CitationGhaffar FA, Vaseem M, Bray JR, Shamim A (2017) A half mode inkjet printed tunable ferrite isolator. 2017 IEEE MTT-S International Microwave Symposium (IMS). Available: http://dx.doi.org/10.1109/MWSYM.2017.8059099.
Conference/Event name2017 IEEE MTT-S International Microwave Symposium, IMS 2017