Theoretical modeling and experimental validation of transport and separation properties of carbon nanotube electrospun membrane distillation
AuthorsLee, Jung Gil
An, Alicia Kyoungjin
KAUST DepartmentBiological and Environmental Sciences and Engineering (BESE) Division
Water Desalination and Reuse Research Center (WDRC)
Permanent link to this recordhttp://hdl.handle.net/10754/622098
MetadataShow full item record
AbstractDeveloping a high flux and selective membrane is required to make membrane distillation (MD) a more attractive desalination process. Amongst other characteristics membrane hydrophobicity is significantly important to get high vapor transport and low wettability. In this study, a laboratory fabricated carbon nanotubes (CNTs) composite electrospun (E-CNT) membrane was tested and has showed a higher permeate flux compared to poly(vinylidene fluoride-co-hexafluoropropylene) (PH) electrospun membrane (E-PH membrane) in a direct contact MD (DCMD) configuration. Only 1% and 2% of CNTs incorporation resulted in an enhanced permeate flux with lower sensitivity to feed salinity while treating a 35 and 70 g/L NaCl solutions. Experimental results and the mechanisms of E-CNT membrane were validated by a proposed new step-modeling approach. The increased vapor transport in E-CNT membranes could not be elucidated by an enhancement of mass transfer only at a given physico-chemical properties. However, the theoretical modeling approach considering the heat and mass transfers simultaneously enabled to explain successfully the enhanced flux in the DCMD process using E-CNT membranes. This indicates that both mass and heat transfers improved by CNTs are attributed to the enhanced vapor transport in the E-CNT membrane.
CitationLee J-G, Lee E-J, Jeong S, Guo J, An AK, et al. (2016) Theoretical modeling and experimental validation of transport and separation properties of carbon nanotube electrospun membrane distillation. Journal of Membrane Science. Available: http://dx.doi.org/10.1016/j.memsci.2016.12.045.
SponsorsThe research reported in this paper was supported by King Abdullah University of Science and Technology (KAUST), Saudi Arabia, and University Grants Committee of the Hong Kong for Early Career Scheme (UGC ECS/GRF Project number: 9048074).
JournalJournal of Membrane Science