Show simple item record

dc.contributor.advisorDa Costa, Pedro M. F. J.
dc.contributor.authorHolguin Lerma, Jorge Alberto
dc.date.accessioned2016-05-15T06:25:06Z
dc.date.available2016-05-15T06:25:06Z
dc.date.issued2016-05-03
dc.identifier.doi10.25781/KAUST-9D196
dc.identifier.urihttp://hdl.handle.net/10754/609435
dc.description.abstractFor years, electron beam induced deposition has been used to fabricate electrical contacts for micro and nanostructures. The role of the contact resistance is key to achieve high performance and efficiency in electrical devices. The present thesis reports on the electrical, structural and chemical characterization of electron beam deposited platinum electrodes that are exposed to different steps of thermal annealing and how they are used in four-probe devices of ultrathin graphite (uG) flakes (<100nm thickness). The device integration of liquid phase exfoliated uG is demonstrated, and its performance compared to devices made with analogous mechanically exfoliated uG. For both devices, similar contact resistances of ~2kΩ were obtained. The electrical measurements confirm a 99.5% reduction in contact resistance after vacuum thermal annealing at 300 °C. Parallel to this, Raman characterization confirms the formation of a nanocrystalline carbon structure over the electrode. While this could suggest an enhancement of the electrical transport in the device, an additional thermal annealing step in air at 300 °C, promoted the oxidation and removal of the carbon shell and confirmed that the contact resistance remained the same. Overall this shows that the carbon shell along the electrode has no significant role in the contact resistance. Finally, the challenges based on topographical analysis of the deposited electrodes are discussed. Reduction of the electrode’s height down to one-third of the initial value, increased surface roughness, formation of voids along the electrodes and the onset of platinum nanoparticles near the area of deposition, represent a challenge for future work.
dc.language.isoen
dc.subjectContact
dc.subjectGraphene
dc.subjectGraphite
dc.subjectDevice
dc.subjectAnnealing
dc.titleCharacterization of Deposited Platinum Contacts onto Discrete Graphene Flakes for Electrical Devices
dc.typeThesis
dc.contributor.departmentMaterial Science and Engineering Program
dc.contributor.departmentPhysical Science and Engineering (PSE) Division
thesis.degree.grantorKing Abdullah University of Science and Technology
dc.contributor.committeememberLi, Lain-Jong
dc.contributor.committeememberOoi, Boon S.
thesis.degree.disciplineMaterials Science and Engineering
thesis.degree.nameMaster of Science
refterms.dateFOA2017-05-15T00:00:00Z


Files in this item

Thumbnail
Name:
Jorge Holguin Lerma - Thesis - Final Draft.pdf
Size:
17.46Mb
Format:
PDF

This item appears in the following Collection(s)

Show simple item record