Show simple item record

dc.contributor.authorRen, Lijiao
dc.contributor.authorZhang, Xiaoyuan
dc.contributor.authorHe, Weihua
dc.contributor.authorLogan, Bruce E.
dc.date.accessioned2016-02-25T13:21:10Z
dc.date.available2016-02-25T13:21:10Z
dc.date.issued2014-08-05
dc.identifier.citationRen L, Zhang X, He W, Logan BE (2014) High current densities enable exoelectrogens to outcompete aerobic heterotrophs for substrate. Biotechnology and Bioengineering 111: 2163–2169. Available: http://dx.doi.org/10.1002/bit.25290.
dc.identifier.issn0006-3592
dc.identifier.pmid24889278
dc.identifier.doi10.1002/bit.25290
dc.identifier.urihttp://hdl.handle.net/10754/598464
dc.description.abstract© 2014 Wiley Periodicals, Inc. Chemical oxygen demand (COD) removal rates could be described by first-order kinetics with respect to COD concentration at different current densities, even under open circuit conditions with no current generation. The COD concentration was reduced more quickly with current generation due to the greater consumption of substrate by exoelectrogens, and less substrate was lost to aerobic heterotrophs. Higher current densities enabled exoelectrogens to outcompete aerobic heterotrophs for substrate, allowing for increased coulombic efficiencies with current densities. © 2014 Wiley Periodicals, Inc. In mixed-culture microbial fuel cells (MFCs), exoelectrogens and other microorganisms compete for substrate. It has previously been assumed that substrate losses to other terminal electron acceptors over a fed-batch cycle, such as dissolved oxygen, are constant. However, a constant rate of substrate loss would only explain small increases in coulombic efficiencies (CEs, the fraction of substrate recovered as electrical current) with shorter cycle times, but not the large increases in CE that are usually observed with higher current densities and reduced cycle times. To better understand changes in CEs, COD concentrations were measured over time in fed-batch, single-chamber, air-cathode MFCs at different current densities (external resistances). COD degradation rates were all found to be first-order with respect to COD concentration, even under open circuit conditions with no current generation (first-order rate constant of 0.14±0.01h-1). The rate of COD removal increased when there was current generation, with the highest rate constant (0.33±0.02h-1) obtained at the lowest external resistance (100Ω). Therefore, as the substrate concentration was reduced more quickly due to current generation, the rate of loss of substrate to non-exoelectrogens decreased due to this first-order substrate-concentration dependence. As a result, coulombic efficiencies rapidly increased due to decreased, and not constant, removal rates of substrate by non-exoelectrogens. These results show that higher current densities (lower resistances) redirect a greater percentage of substrate into current generation, enabling large increase in CEs with increased current densities. Biotechnol. Bioeng. 2014;111: 2163-2169.
dc.description.sponsorshipContract grant sponsor: King Abdullah University of Science and Technology (KAUST)Contract grant number: KUS-I1-003-13
dc.publisherWiley
dc.subjectCurrent densities
dc.subjectExoelectrogens
dc.subjectHeterotrophs
dc.subjectMicrobial fuel cell
dc.subjectSubstrate consumption
dc.titleHigh current densities enable exoelectrogens to outcompete aerobic heterotrophs for substrate
dc.typeArticle
dc.identifier.journalBiotechnology and Bioengineering
dc.contributor.institutionDepartment of Civil and Environmental Engineering; 212 Sackett Building, The Pennsylvania State University; University Park 16802 Pennsylvania
dc.contributor.institutionState Key Laboratory of Urban Water Resource and Environment; Harbin Institute of Technology; Harbin P.R. China
kaust.grant.numberKUS-I1-003-13
dc.date.published-online2014-08-05
dc.date.published-print2014-11


This item appears in the following Collection(s)

Show simple item record