Show simple item record

dc.contributor.authorTaamallah, Soufien
dc.contributor.authorLaBry, Zachary A.
dc.contributor.authorShanbhogue, Santosh J.
dc.contributor.authorGhoniem, Ahmed F.
dc.date.accessioned2016-02-25T12:58:22Z
dc.date.available2016-02-25T12:58:22Z
dc.date.issued2014-09-18
dc.identifier.citationTaamallah S, LaBry ZA, Shanbhogue SJ, Ghoniem AF (2014) Correspondence Between Uncoupled Flame Macrostructures and Thermoacoustic Instability in Premixed Swirl-Stabilized Combustion. Volume 4B: Combustion, Fuels and Emissions. Available: http://dx.doi.org/10.1115/gt2014-27316.
dc.identifier.doi10.1115/gt2014-27316
dc.identifier.urihttp://hdl.handle.net/10754/597887
dc.description.abstractIn this paper, we conduct an experimental investigation of a confined premixed swirl-stabilized dump combustor similar to those found in modern gas turbines. We operate the combustor with premixed methane-air in the lean range of equivalence ratio ϕ ∈ [0.5–0.75]. First, we observe different dynamic modes in the lean operating range, as the equivalence ratio is raised, confirming observations made previously in a similar combustor geometry but with a different fuel [1]. Next we examine the correspondence between dynamic mode transitions and changes in the mean flame configuration or macrostructure. We show that each dynamic mode is associated with a specific flame macrostructure. By modifying the combustor length without changing the underlying flow, the resonant frequencies of the geometry are altered allowing for decoupling the heat release fluctuations and the acoustic field, in a certain range of equivalence ratio. Mean flame configurations in the modified (short) combustor and for the same range of equivalence ratio are examined. It is found that not only the same sequence of flame configurations is observed in both combustors (long and short) but also that the set of equivalence ratio where transitions in the flame configuration occur is closely related to the onset of thermo-acoustic instabilities. For both combustor lengths, the flame structure changes at similar equivalence ratio whether thermo-acoustic coupling is allowed or not, suggesting that the flame configuration holds the key to understanding the onset of self-excited thermo-acoustic instability in this range. Finally, we focus on the flame configuration transition that was correlated with the onset of the first dynamically unstable mode ϕ ∈ [0.61–0.64]. Our analysis of this transition in the short, uncoupled combustor shows that it is associated with an intermittent appearance of a flame in the outer recirculation zone (ORZ). The spectral analysis of this “ORZ flame flickering” — based on flame chemiluminescence data — shows the presence of unsteady events occurring at two distinct frequency ranges. A broad band at low frequency in the range ∼[1 Hz – 10 Hz] and a narrow band centered around 28 Hz.
dc.description.sponsorshipThis work was supported by the King Fahd University ofPetroleum and Minerals (KFUPM) and King Abdullah Universityof Science and Technology (KAUST) in Saudi Arabia, underthe grant numbers R12-CE-10 and KUS-110-010-01, respectively.
dc.publisherASME International
dc.titleCorrespondence Between Uncoupled Flame Macrostructures and Thermoacoustic Instability in Premixed Swirl-Stabilized Combustion
dc.typeConference Paper
dc.identifier.journalVolume 4B: Combustion, Fuels and Emissions
dc.contributor.institutionMassachusetts Institute of Technology, Cambridge, MA
kaust.grant.numberKUS-110-010-01
dc.date.published-online2014-09-18
dc.date.published-print2014-06-16


This item appears in the following Collection(s)

Show simple item record