Autoignition characteristics of laminar lifted jet flames of pre-vaporized iso-octane in heated coflow air
KAUST DepartmentClean Combustion Research Center
Combustion and Laser Diagnostics Laboratory
Mechanical Engineering Program
Physical Science and Engineering (PSE) Division
Permanent link to this recordhttp://hdl.handle.net/10754/594241
MetadataShow full item record
AbstractThe stabilization characteristics of laminar non-premixed jet flames of pre-vaporized iso-octane, one of the primary reference fuels for octane rating, have been studied experimentally in heated coflow air. Non-autoignited and autoignited lifted flames were analyzed. With the coflow air at relatively low initial temperatures below 940 K, an external ignition source was required to stabilize the flame. These lifted flames had tribrachial edge structures and their liftoff heights correlated well with the jet velocity scaled by stoichiometric laminar burning velocity, indicating the importance of the edge propagation speed on flame stabilization. At high initial temperatures over 940 K, the autoignited flames were stabilized without requiring an external ignition source. These autoignited lifted flames exhibited either tribrachial edge structures or mild combustion behaviors depending on the level of fuel dilution. Two distinct transition behaviors were observed in the autoignition regime from a nozzle-attached flame to a lifted tribrachial-edge flame and then to lifted mild combustion as the jet velocity increased at a certain fuel dilution level. The liftoff data of the autoignited flames with tribrachial edges were analyzed based on calculated ignition delay times. Analysis of the experimental data suggested that ignition delay time may be much less sensitive to initial temperature under atmospheric pressure conditions as compared with predictions. © 2015 Elsevier Ltd. All rights reserved.
CitationAl-Noman SM, Choi SK, Chung SH (2015) Autoignition characteristics of laminar lifted jet flames of pre-vaporized iso-octane in heated coflow air. Fuel 162: 171–178. Available: http://dx.doi.org/10.1016/j.fuel.2015.09.006.