Comparison of filters: Inkjet printed on PEN substrate versus a laser-etched on LCP substrate
KAUST DepartmentComputer, Electrical and Mathematical Sciences and Engineering (CEMSE) Division
Electrical Engineering Program
Integrated Microwave Packaging Antennas and Circuits Technology (IMPACT) Lab
Permanent link to this recordhttp://hdl.handle.net/10754/564998
MetadataShow full item record
AbstractIn this paper, microstrip-based bandpass filters on polyethylene naphthalate (PEN) and liquid crystal polymers (LCP) are presented to investigate the performance of filters on ultra-thin substrates. PEN (with a thickness of 120 μm) has been characterized and used for a filter for the first time. In addition to being low cost and transparent, it demonstrates comparable RF performance to LCP. The conductor losses are compared by fabricating filters with inkjet printed lines as well as laser etched copper clad LCP sheets. With 5 layers of inkjet printing, and a curing temperature below 200°C, a final silver thickness of 2 μm and conductivity of 9.6 × 106 S/m are achieved. The designs are investigated at two frequencies, 24 GHz as well as 5 GHz to assess their performance at high and low frequencies respectively. The 24 GHz inkjet printed filter shows an insertion loss of 2 dB, while the 5 GHz design gives an insertion loss of 8 dB. We find that thin substrates have a strong effect on the insertion loss of filters especially as the frequency is reduced. The same design, realized on LCP (thickness of 100 μm) through laser etching, demonstrates a very similar performance, thus verifying this finding. © 2014 European Microwave Association.
Conference/Event name2014 44th European Microwave Conference, EuMC 2014 - Held as Part of the 17th European Microwave Week, EuMW 2014