Uniform and non-uniform inlet temperature of a vertical hot water jet injected into a rectangular tank
KAUST DepartmentComputational Transport Phenomena Lab
Physical Sciences and Engineering (PSE) Division
Environmental Science and Engineering Program
MetadataShow full item record
AbstractIn most of real-world applications, such as the case of heat stores, inlet is not kept at a constant temperature but it may vary with time during charging process. In this paper, a vertical water jet injected into a rectangular storage tank is measured experimentally and simulated numerically. Two cases of study are considered; one is a hot water jet with uniform inlet temperature (UIT) injected into a cold water tank, and the other is a cold water jet with non-uniform inlet temperature (NUIT) injected into a hot water tank. Three different temperature differences and three different flow rates are studied for the hot water jet with UIT which is injected into a cold water tank. Also, three different initial temperatures with constant flow rate as well as three different flow rates with constant initial temperature are considered for the cold jet with NUIT which is injected into a hot water tank. Turbulence intensity at the inlet as well as Reynolds number for the NUIT cases are therefore functions of inlet temperature and time. Both experimental measurements and numerical calculations are carried out for the same measured flow and thermal conditions. The realizable k-ε model is used for modeling the turbulent flow. Numerical solutions are obtained for unsteady flow while pressure, velocity, temperature and turbulence distributions inside the water tank are analyzed. The simulated results are compared to the measured results, and they show a good agreement at low temperatures. © 2010 IEEE.
Journal2010 3rd International Conference on Thermal Issues in Emerging Technologies Theory and Applications
Conference/Event name2010 3rd International Conference on Thermal Issues in Emerging Technologies, Theory and Applications, ThETA3 2010