Show simple item record

dc.contributor.authorLouie, Jennifer Sarah
dc.contributor.authorPinnau, Ingo
dc.contributor.authorReinhard, Martin
dc.date.accessioned2015-08-02T09:14:36Z
dc.date.available2015-08-02T09:14:36Z
dc.date.issued2011-02
dc.identifier.issn03767388
dc.identifier.doi10.1016/j.memsci.2010.10.067
dc.identifier.urihttp://hdl.handle.net/10754/561577
dc.description.abstractThe application of polymer surface coatings to improve the fouling resistance of reverse osmosis membranes tends to increase flow resistance across the membrane. This paper presents a systematic analysis on how membrane properties and performance are impacted by the coating process steps, and investigates how such effects could contribute to lower water flux. On one hand, simply pre-soaking dry aromatic polyamide composite membranes in aliphatic alcohols results in a significant increase in water flux, which is attributed to wetting of pores in the selective polyamide layer and to changes in the polymer structure. This flux increase was not readily reversible, based on a 300-h water permeation test. Conversely, drying a wetted membrane led to a decrease in water flux, which we hypothesize is caused by increased interchain hydrogen-bonding in the selective layer. This drop in water flux was not permanent; higher flux was observed if the same wetted/dried membrane was then re-soaked in ethanol prior to the water permeation experiment. An ethanol pre-soaking step also increased water flux of a PEBAX-coated membrane by nearly 70%. In contrast to the reduction in water flux caused by the specific treatment sequence of ethanol-swelling followed by drying, this same sequence actually increased gas transport. The eight- to ten-fold increase in Knudsen diffusion-based gas permeance after this pre-treatment was attributed to an increase in the number or size of membrane defects. © 2010 Elsevier B.V.
dc.description.sponsorshipThis work was funded by the Santa Clara Valley Water District (Agreement A2727A), the Metropolitan Water District (Agreement 41808), the California Department of Water Resources, the WateReuse Foundation (WRF-06-020) and Singapore Economic Development Board. Membranes used for this study were generously donated by Hydranautics (Oceanside, CA). Membrane Technology and Research, Inc. is gratefully acknowledged for providing water and gas permeation equipment.
dc.publisherElsevier BV
dc.subjectCoating
dc.subjectGas permeation
dc.subjectPebax
dc.subjectPolyamide
dc.subjectRO membranes
dc.subjectWetting
dc.titleEffects of surface coating process conditions on the water permeation and salt rejection properties of composite polyamide reverse osmosis membranes
dc.typeArticle
dc.contributor.departmentAdvanced Membranes and Porous Materials Research Center
dc.contributor.departmentPhysical Sciences and Engineering (PSE) Division
dc.contributor.departmentChemical and Biological Engineering Program
dc.identifier.journalJournal of Membrane Science
dc.contributor.institutionDepartment of Civil and Environmental Engineering, Stanford University, Environment and Energy Building, 473 Via Ortega, Stanford,CA,94305-4020, United States
kaust.personPinnau, Ingo


This item appears in the following Collection(s)

Show simple item record