Sun, Haiding; Li, Kuang-Hui; Castanedo, C. G. Torres; Okur, Serdal; Tompa, Gary S.; Salagaj, Tom; Lopatin, Sergei; Genovese, Alessandro; Li, Xiaohang(Crystal Growth & Design, American Chemical Society (ACS), 2018-03-06)[Article]
Precise control of the heteroepitaxy on a low-cost foreign substrate is often the key to drive the success of fabricating semiconductor devices in scale when a large low-cost native substrate is not available. Here, we successfully synthesized three different phases of Ga2O3 (α, β, and ε) films on c-plane sapphire by only tuning the flow rate of HCl along with other precursors in an MOCVD reactor. A 3-fold increase in the growth rate of pure β-Ga2O3 was achieved by introducing only 5 sccm of HCl flow. With continuously increased HCl flow, a mixture of β- and ε-Ga2O3 was observed, until the Ga2O3 film transformed completely to a pure ε-Ga2O3 with a smooth surface and the highest growth rate (∼1 μm/h) at a flow rate of 30 sccm. At 60 sccm, we found that the film tended to have a mixture of α- and ε-Ga2O3 with a dominant α-Ga2O3, while the growth rate dropped significantly (∼0.4 μm/h). The film became rough as a result of the mixture phases since the growth rate of ε-Ga2O3 is much higher than that of α-Ga2O3. In this HCl-enhanced MOCVD mode, the Cl impurity concentration was almost identical among the investigated samples. On the basis of our density functional theory calculation, we found that the relative energy between β-, ε-, and α-Ga2O3 became smaller, thus inducing the phase change by increasing the HCl flow in the reactor. Thus, it is plausible that the HCl acted as a catalyst during the phase transformation process. Furthermore, we revealed the microstructure and the epitaxial relationship between Ga2O3 with different phases and the c-plane sapphire substrates. Our HCl-enhanced MOCVD approach paves the way to achieving highly controllable heteroepitaxy of Ga2O3 films with different phases for device applications.
Bose, Riya; Adhikari, Aniruddha; Burlakov, Victor M; Liu, Guangyu; Haque, Mohammed; Priante, Davide; Hedhili, Mohamed N.; Wehbe, Nimer; Zhao, Chao; Yang, Haoze; Ng, Tien Khee; Goriely, Alain; Bakr, Osman; Wu, Tao; Ooi, Boon S.; Mohammed, Omar F.(ACS Energy Letters, American Chemical Society (ACS), 2018-01-23)[Article]
Introducing dopants into InGaN NWs is known to significantly improve their device performances through a variety of mechanisms. However, to further optimize device operation under the influence of large specific surfaces, a thorough knowledge of ultrafast dynamical processes at the surface and interface of these NWs is imperative. Here, we describe the development of four-dimensional scanning ultrafast electron microscopy (4D S-UEM) as an extremely surface-sensitive method to directly visualize in space and time the enormous impact of silicon doping on the surface-carrier dynamics of InGaN NWs. Two time regime dynamics are identified for the first time in a 4D S-UEM experiment: an early time behavior (within 200 picoseconds) associated with the deferred evolution of secondary electrons due to the presence of localized trap states that decrease the electron escape rate and a longer timescale behavior (several ns) marked by accelerated charge carrier recombination. The results are further corroborated by conductivity studies carried out in dark and under illumination.
Singh, Shivkant; Shervin, Shahab; Sun, Haiding; Yarali, Milad; Chen, Jie; Lin, Ronghui; Li, Kuang-Hui; Li, Xiaohang; Ryou, Jae-Hyun; Mavrokefalos, Anastassios(ACS Applied Materials & Interfaces, American Chemical Society (ACS), 2018-05-17)[Article]
The effect of controlling the c-axis alignment (mosaicity) to the cross-plane thermal transport in textured polycrystalline aluminum nitride (AlN) thin films is experimentally and theoretically investigated. We show that by controlling the sputtering conditions we are able to deposit AlN thin films with varying c-axis grain tilt (mosaicity) from 10° to 0°. Microstructural characterization shows that the films are nearly identical in thickness and grain size, and the difference in mosaicity alters the grain interface quality. This has a significant effect to thermal transport where a thermal conductivity of 4.22 W/mK vs. 8.09 W/mK are measured for samples with tilt angles of 10° vs. 0° respectively. The modified Callaway model was used to fit the theoretical curves to the experimental results using various phonon scattering mechanisms at the grain interface. It was found that using a non-gray model gives an overview of the phonon scattering at the grain boundaries, whereas treating the grain boundary as an array of dislocation lines with varying angle relative to the heat flow, best describes the mechanism of the thermal transport. Lastly, our results show that controlling the quality of the grain interface provides a tuning knob to control thermal transport in polycrystalline materials.
Export search results
The export option will allow you to export the current search results of the entered query to a file. Different
formats are available for download. To export the items, click on the button corresponding with the preferred download format.
By default, clicking on the export buttons will result in a download of the allowed maximum amount of items.
For anonymous users the allowed maximum amount is 50 search results.
To select a subset of the search results, click "Selective Export" button and make a selection of the items you want to export.
The amount of items that can be exported at once is similarly restricted as the full export.
After making a selection, click one of the export format buttons. The amount of items that will be exported is indicated in the bubble next to export format.