We achieved considerable laser diode (LD) improvement after annealing InGaP/InAlGaP laser structure at 950°C for a total annealing time of 2 min. The photoluminescence intensity is increased by 10 folds and full-wave at half-maximum is reduced from ∼30 to 20 nm. The measured LDs exhibited significantly reduced threshold current (Ith), from 2 to 1.5 A for a 1-mm long LD, improved internal efficiency (ηi), from 63% to 68%, and increased internal losses αi, from 14.3 to 18.6 cm−1. Our work suggests that the use of strain-induced quantum well intermixing is a viable solution for high-efficiency AlGaInP devices at shorter wavelengths. The advent of laser-based solid-state lighting (SSL) and visible-light communications (VLC) highlighted the importance of the current findings, which are aimed at improving color quality and photodetector received power in SSL and VLC, respectively, via annealed red LDs.

We report an optically pumped green perovskite vertical-cavity surface-emitter operating in continuous-wave (CW) with a power density threshold of ~89 kW/cm2. The device has an active region of CH3NH3PbBr3 embedded in a dielectric microcavity; this feat was achieved with a combination of optimal spectral alignment of the optical cavity modes with the perovskite optical gain, an adequate Q-factor of the microcavity, adequate thermal stability, and improved material quality with a smooth, passivated, and annealed thin active layer. Our results signify a way towards efficient CW perovskite emitter operation and electrical injection using low-cost fabrication methods for addressing monolithic optoelectronic integration and lasing in the green gap.

We report an unusual thermal quenching of the micro-photoluminescence (µ-PL) intensity for a sandwiched single-layer (SL) MoS2. For this study, MoS2 layers were chemical vapor deposited on molecular beam epitaxial grown In0.15Al0.85N lattice matched templates. Later, to accomplish air-stable sandwiched SL-MoS2, a thin In0.15Al0.85N cap layer was deposited on the MoS2/In0.15Al0.85N heterostructure. We confirm that the sandwiched MoS2 is a single layer from optical and structural analyses using µ-Raman spectroscopy and scanning transmission electron microscopy, respectively. By using high-resolution X-ray photoelectron spectroscopy, no structural phase transition of MoS2 is noticed. The recombination processes of bound and free excitons were analyzed by the power-dependent µ-PL studies at 77 K and room temperature (RT). The temperature-dependent micro photoluminescence (TDPL) measurements were carried out in the temperature range of 77 – 400 K. As temperature increases, a significant red-shift is observed for the free-exciton PL peak, revealing the delocalization of carriers. Further, we observe unconventional negative thermal quenching behavior, the enhancement of the µ-PL intensity with increasing temperatures up to 300K, which is explained by carrier hopping transitions that take place between shallow localized states to the band-edges. Thus, this study renders a fundamental insight into understanding the anomalous thermal quenching of µ-PL intensity of sandwiched SL-MoS2.

The use of autonomous underwater vehicles (AUVs) is highly desirable for collecting data from seafloor sensor platforms within a close range. With the recent innovations in underwater wireless optical communication (UWOC) for deep-sea exploration, UWOC could be used in conjunction with AUVs for high-speed data uploads near the surface. In addition to absorption and scattering effects, UWOC undergoes scintillation induced by temperature- and salinity-related turbulence. However, studies on scintillation have been limited to emulating channels with uniform temperature and salinity gradients, rather than incorporating the effects of turbulent motion. Such turbulent flow results in an ocean mixing process that degrades optical communication. This study presents a turbulent model for investigating the impact of vehicle-motion-induced turbulence via the turbulent kinetic energy dissipation rate. This scintillation-related parameter offers a representation of the change in the refractive index (RI) due to the turbulent flow and ocean mixing. Monte Carlo simulations are carried out to validate the impact of turbulent flow on optical scintillation. In experimental measurements, the scintillation index (SI) and signal-to-noise ratio (SNR) are similar with (SI = 0.4824, SNR = 5.56) and without (SI = 0.4823, SNR = 5.87) water mixing under uniform temperature channels. By introducing a temperature gradient of 4 °C, SI (SNR) with and without turbulent flow changed to 0.5417 (5.06) and 0.8790 (3.40), respectively. The experimental results show a similar trend with the simulation results. Thus, turbulent flow was shown to significantly impact underwater optical communications.

Single and multiple wavelength laser systems are presented that employ self-injection locked InGaN/GaN green laser diodes in an external cavity configuration with a partially reflective mirror. A stable and simultaneous locking of up to four longitudinal Fabry–Perot modes of the system cavity is demonstrated with appreciable signal-to-noise-ratio of ∼13 dB and average mode linewidth of ∼150 pm. The multi-wavelength spectrum exhibited a flat-top emission with nearly equal power distribution among the modes and an analogous mode spacing of ∼0.5 nm. This first demonstration of multi-wavelength generation source is highly attractive in a multitude of cross-disciplinary field applications besides asserting the prospects of narrow wavelength spaced multiplexed visible light communication. Moreover, an extended two-stage self-injection locked near single wavelength visible laser system is also presented. An ultra-narrow linewidth of ∼34 pm is realized at 525.05 nm locked wavelength from this innovative system, with ∼20 dB side-mode-suppression-ratio; thus signifying a paradigm shift toward semiconductor lasers for near single lasing wavelength generation, which is presently dominated by other kinds of laser technologies.

Group-III-nitride superluminescent diodes (SLDs) are emerging as light sources for white lighting and visible light communications (VLC) owing to their droop-free, low speckle noise and large modulation bandwidth properties. In this study, we discuss the development of GaN-based visible SLDs, and analyze their electro-optical properties by studying the optical power-bandwidth products (PBPs) and injection current densities. The significant progress in blue SLDs and their applications for white light VLC is highlighted. A blue SLD, with an optical power of > 100 mW and large PBP of 536 mW.nm, is utilized to generate white light, resulting in a high CRI of 88.2. In a modulation experiment designed for an SLD-based VLC system, an on-off keying scheme exhibits a 1.2 Gbps data rate, with a bit error rate (BER) of 1.8 × 10-3, which satisfies the forward error correction (FEC) criteria. A high data rate of 3.4 Gbps is achieved using the same SLD transmitter, by applying the 16-QAM discrete multi-tone (DMT) modulation scheme for high-speed white light communication. The results reported here unequivocally point to the significant performance and versatility that GaN-based SLDs could offer for beyond-5G implementation, where white lighting and high spectral efficiency VLC systems can be simultaneously implemented.

Currently the AlGaN-based ultraviolet (UV) solid-state lighting research suffers from numerous challenges. In particular, low internal quantum efficiency, low extraction efficiency, inefficient doping, large polarization fields, and high dislocation density epitaxy constitute bottlenecks in realizing high power devices. Despite the clear advantage of quantum-confinement nanostructure, it has not been widely utilized in AlGaN-based nanowires. Here we utilize the self-assembled nanowires (NWs) with embedding quantum-disks (Qdisks) to mitigate these issues, and achieve UV emission of 337 nm at 32 A/cm (80 mA in 0.5 × 0.5 mm device), a turn-on voltage of ∼5.5 V and droop-free behavior up to 120 A/cm of injection current. The device was grown on a titanium-coated n-type silicon substrate, to improve current injection and heat dissipation. A narrow linewidth of 11.7 nm in the electroluminescence spectrum and a strong wavefunctions overlap factor of 42% confirm strong quantum confinement within uniformly formed AlGaN/AlGaN Qdisks, verified using transmission electron microscopy (TEM). The nitride-based UV nanowires light-emitting diodes (NWs-LEDs) grown on low cost and scalable metal/silicon template substrate, offers a scalable, environment friendly and low cost solution for numerous applications, such as solid-state lighting, spectroscopy, medical science and security.

III-nitride LEDs are fundamental components for visible-light communication (VLC). However, the modulation bandwidth is inherently limited by the relatively long carrier lifetime. In this letter, we present the 405 nm emitting superluminescent diode (SLD) with tilted facet design on semipolar GaN substrate, showing a broad emission of ∼9 nm at 20 mW optical power. Owing to the fast recombination (τ<0.35 ns) through the amplified spontaneous emission, the SLD exhibits a significantly large 3-dB bandwidth of 807 MHz. A data rate of 1.3 Gbps with a bit-error rate of 2.9 × 10 was obtained using on-off keying modulation scheme, suggesting the SLD being a high-speed transmitter for VLC applications.

Recent interest in two-dimensional materials has resulted in ultra-thin devices based on the transfer of transition metal dichalcogenides (TMDs) onto other TMDs or III-nitride materials. In this investigation, we realized p-type monolayer (ML) MoS2, and intrinsic GaN/p-type MoS2 heterojunction by the GaN overgrowth on ML-MoS2/c-sapphire using the plasma-assisted molecular beam epitaxy. A systematic nitrogen plasma (N∗2N2*) and gallium (Ga) irradiation studies are employed to understand the individual effect on the doping levels of ML-MoS2, which is evaluated by micro-Raman and high-resolution X-Ray photoelectron spectroscopy (HRXPS) measurements. With both methods, p-type doping was attained and was verified by softening and strengthening of characteristics phonon modes E12gE2g1 and A1gA1g from Raman spectroscopy. With adequate N∗2N2*-irradiation (3 min), respective shift of 1.79 cm−1 for A1gA1g and 1.11 cm−1 for E12gE2g1 are obtained while short term Ga-irradiated (30 s) exhibits the shift of 1.51 cm−1 for A1gA1g and 0.93 cm−1 for E12gE2g1. Moreover, in HRXPS valence band spectra analysis, the position of valence band maximum measured with respect to the Fermi level is determined to evaluate the type of doping levels in ML-MoS2. The observed values of valance band maximum are reduced to 0.5, and 0.2 eV from the intrinsic value of ≈1.0 eV for N∗2N2*- and Ga-irradiated MoS2 layers, which confirms the p-type doping of ML-MoS2. Further p-type doping is verified by Hall effect measurements. Thus, by GaN overgrowth, we attained the building block of intrinsic GaN/p-type MoS2 heterojunction. Through this work, we have provided the platform for the realization of dissimilar heterostructure via monolithic approach.

A droop-free nitride light-emitting diode (LED) with the capacity to operate beyond the “green gap” has been a subject of intense scientific and engineering interest. While several properties of nanowires on silicon make them promising for use in LED development, the high aspect ratio of individual nanowires and their laterally discontinuous features limit phonon transport and device performance. Here, we report on the monolithic integration of metal heat-sink and droop-free InGaN/GaN quantum-disks-in-nanowire LEDs emitting at ∼710 nm. The reliable operation of our uncooled nanowire-LEDs (NW-LEDs) epitaxially grown on molybdenum was evident in the constant-current soft burn-in performed on a 380 μm × 380 μm LED. The square LED sustained 600 mA electrical stress over an 8 h period, providing stable light output at maturity without catastrophic failure. The absence of carrier and phonon transport barriers in NW-LEDs was further inferred from current-dependent Raman measurements (up to 700 mA), which revealed the low self-heating. The radiative recombination rates of NW-LEDs between room temperature and 40 °C was not limited by Shockley–Read–Hall recombination, Auger recombination, or carrier leakage mechanisms, thus realizing droop-free operation. The discovery of reliable, droop-free devices constitutes significant progress toward the development of nanowires for practical applications. Our monolithic approach realized a high-performance device that will revolutionize the way high power, low-junction-temperature LED lamps are manufactured for solid-state lighting and for applications in high-temperature harsh environment.